Ready-mixed concrete must be moistened and lubricated before starting the pump. The pump truck and pipelines must be wetted and lubricated. For the past few decades, the ready-mixed concrete industry across the country has been using water and mortar to moisten pipes, which is costly and wastes materials and vehicles. The developed lubricant can reduce costs, achieve good results, save water, vehicles and energy, and has good prospects for promotion.
Usage: This product can replace the concrete pumping lubrication mortar without affecting the performance of the concrete.
Ready-mixed concrete must be moistened and lubricated before starting the pump. The pump truck and pipelines must be wetted and lubricated. For the past few decades, the ready-mixed concrete industry across the country has been using water and mortar to moisten pipes, which is costly and wastes materials and vehicles. Through the developed lubricant, the cost is reduced, the effect is good, and water, vehicles and energy are saved.
Product performance: High-efficiency lubricating agent for concrete pumps can be used to replace traditional lubricating mortar. It is mainly composed of polymer materials, has no effect on the setting time and strength of concrete, and does not cause corrosion to steel bars.
Scope of use: This product can be used for the lubrication pipes of all concrete pump trucks. There is no requirement for the strength level of the concrete.
Usage:
1. In the concrete pump (car pump, trailer pump or Add the appropriate amount of water in the table below into the discharge hopper of the vehicle-mounted pump), start the hopper stirring system, slowly add this product, stir for 5 minutes, and let it sit for a while to make the solution thickened (or add an appropriate amount of water in a plastic bucket, Slowly add this product while stirring with a wooden stick. Stir for 5 minutes and let it sit for a while to make the solution thicken, then pour it into the unloading hopper).
</p
微信扫一扫打赏
