Before concrete pumping construction, first take the required amount of clean dissolved water and pour it into the container, then slowly add the pump truck lubricant, stir while adding until all is dissolved, then let it stand for 3-5 minutes, and stir again Ready to use. When using a truck pump to pump concrete, slowly pour the prepared Pump Runtong solution into the hopper along the inner wall of the pump truck hopper, and then start to slowly pour concrete into the hopper. After the concrete covers the feed port of the delivery pump, you can Start pumping concrete and ready-mixed mortar under pressure. The method is the same when using ground pumps and mortar pumping equipment.
The material produced to replace the traditional pump mortar for a pair of concrete pumps and pump pipe lubrication has large molecules, high viscosity, fast dissolution speed, no insoluble matter, and no corrosion to steel bars. , neutral pH value, does not change the original strength characteristics of concrete, the use of this product can improve the pumping capacity of concrete and shorten the operation time. Then slowly and evenly add the lubricating agent product to the water, and stir continuously (you can open the swing valve of the pump truck, so that the swing valve of the pump truck swings back and forth in the bucket more than 3 times) until the product dissolves, then turn on the positive pump, and The solution in the pipe is pumped out, and at the same time, the concrete is poured into the hopper and the pumping operation is completed. The method is the same when using a ground pump. </p
微信扫一扫打赏
