Concrete pump lubricating agent is used to replace mortar for pump lubricating, making pumping construction more energy-saving and economical.
1. Product Description: Concrete pump lubricating agent is compounded from a variety of high molecular polymer materials. At normal temperature, it can be quickly dissolved within 2-4 minutes by mechanical or manual stirring, and form a light yellow stable viscous liquid, thereby achieving the effect of lubricating the pump tube without affecting the performance of the concrete. More convenient and can be quickly dissolved at room temperature. More environmentally friendly products, green and environmentally friendly, all degradable. More efficient use of scientific methods and reasonable formulas to achieve more efficient moisturizing
2. Usage: It can be determined according to the type of concrete conveying equipment and the length of the conveying pump pipe. Pour this product into the corresponding volume of water and stir for 2-4 minutes to fully dissolve it. When the solution becomes thick and lubricated, it can be used.
When using a truck pump to pump concrete, add diluted moisturizer Slowly pour the pipe water solution along the inner wall of the pump truck hopper (you can also directly put water in the hopper to dilute the pump agent), and then slowly unload the concrete into the hopper from the other side of the pump pipe feed inlet. When the concrete covers the pump inlet Pressurized pumping can begin when the material enters the inlet. Try to allow all the lubrication solution to flow at the front end of the concrete pipe.
When using a ground pump to pump concrete, in order to prevent any residue left in the pump pipe For residues, 100 kilograms of water should be pumped to clean the pipeline first, and then pumped according to the above steps after the water in the hopper and pipeline is emptied.
Three. Notes
1. There should be no residue in the delivery pump pipe, and the pump pipe connection should be sealed without leakage; when pumping the first truck of concrete, the concrete slump should be increased by 2-3 cm;
2. When using in summer, water should be pumped first to lower the temperature of the pump pipe; the lubrication solution discharged from the pump pipe should not be poured into the concrete structure;
3. Let the lubrication solution flow into the pump tube as much as possible (①. You can first put a small amount of concrete in the hopper to be level with the pipe mouth, and then pour the lubrication solution. ②. Start from the other side of the pump tube inlet with a slower Unload the concrete quickly and squeeze the lubricating solution into the pump tube.)</p
微信扫一扫打赏
