Lubricant can avoid pump clogging accidents in concrete pump trucks and on-site mortar pumps, reduce transportation vehicles, increase equipment utilization, and reduce the cost of ready-mixed concrete and ready-mixed dry powder. The usage cost of mortar users. Many people may be concerned about whether the lubricant is corrosive. Here I can tell you clearly that polyacrylamide is easily soluble in water and almost insoluble in benzene, ether, esters, acetone and other general organic solvents. The aqueous solution is a nearly transparent viscous liquid, which is non-dangerous, non-toxic and non-corrosive. Therefore, you don’t have to worry about the lubricant corroding the pump pipes of the concrete pump truck. Similarly, the construction company does not have to worry about the corrosion of its reinforced concrete and affecting the quality of the project. However, it should be noted that the longer the length of the pump tube, the greater the amount of lubricant used. At the same time, when blending the lubricant into the water, you can increase the stirring time to make it more viscous and moisturize the tube. The effect will also be better.
At the same time, according to relevant research data, after adding moisturizing agent to concrete, the retarding effect on concrete is obvious. , the better the retarding effect. It also has a great impact on the strength of concrete, and the strength gradually increases as the amount of concrete increases. Therefore, it can be said that pipe lubricants have obvious advantages over mortar in all aspects. Nowadays, energy conservation and environmental protection are advocated, and pipe lubricants are a good substitute for mortar. Therefore, when leaving the truck every day, the pump truck must be properly moisturized in advance. Otherwise, the pump truck may not be able to work normally, or various minor problems may occur due to insufficient lubrication.
</p
微信扫一扫打赏
