Super easy method to clean up foam caulk

There are many little tricks in decoration, but many of them are spread onlineFoam caulkCleaning Little tricks are not scientific and reasonable. If some little tricks are used under unreasonable circumstances, , but it will become“a little evil trick”.

This time I would like to share with you about the renovation processLittle knowledge about foam caulking,Foam caulk is a foaming adhesive that we often use when decorating. In most cases, it is used in the installation of door frames and wooden boards. It can be used for wall adhesion and fixation of some furniture, but due to its foaming principle, it is difficult to control the dosage, which will cause Foam caulkoverflow , stained on nearby objects, such as fixed door frames, door frames, etc.

Once these are gluedfoam caulk Agent, the little trick mentioned on the Internet is to use banana water, wind oil Fine and so on, but I think this is a big misunderstanding. In this treatment method, the glue is often not removed, but the paint of the furniture is easily damaged. How to deal with it without damaging the paint surface? Let’s take a look below.

1. AboutFoam caulkIntroduction

Foam caulkAlso called polyurethane foam caulking agent, the main component of the combination is polyurethane, Foam caulkhas the characteristics of foaming expansion and high adhesion. It is commonly used in our decorationFoam caulkingare all high-pressure canned , the polyurethane in the foam is sprayed out by extrusion. The foamy polyurethane reacts with the moisture in the air and will solidify after a period of time..

2. Foam caulking agent‘s main function

1. insect-proof, mouse-proof, waterproof

Foam caulk It can be used to seal air-conditioning holes to prevent insects and mice, and it can also be used to prevent water and moisture.

2. Insulation

<span style=";font-family:宋体;font-size:19px"Pay attention when using seaming agent Matters

1. Clear clutter

The debris in the place of use should be removed before use. If the humidity is less than50 , it should be sprayed with water to allow the foaming agent to better evaporate, otherwise “big holes” will appear.

2. How to use

It needs to be shaken evenly before use, with the head facing down, tightly combined with the spray gun, and only half of the gap is filled.

3. Temperature

When the temperature is lower than10℃, it should be heated with 40-50° hot water. The surface drying time is 5 minutes, and 30 minutes can Cut and allow 24 hours to fully cure.

4. Protection

PaperFoam caulk font>It is best to use newspapers or disposable protective films to protect the surrounding area and try to avoid Foam caulk sticks to unnecessary placesfoam caulk.

Editor’s note: We use bubbles Caulking agentWhen constructing and installing entry door covers, etc., try to use newspapers Or use a disposable protective film to protect the perimeter and avoid cleaningfoam caulking Secondary damage caused by agent. If foam glue is accidentally stuck, Be sure to choose the correct glue removal method. You can either physically remove it or use a professional glue remover. Do not trust some tricks posted online, otherwise it will cause serious damage to the door cover or wood veneer.

The above isauthorHow to remove Foam caulk‘s suggestions, I hope it will be helpful to everyone. If you have better suggestions, welcome everyoneContact the author, Thanks for reading!