There are many pump truck lubricants purchased at construction sites and commercial concrete mixing stations, but the results are not good and the pump truck lubricants are not used to their full potential! The main reasons why pump truck lubricants are not used properly are as follows.
Buyers who have not purchased qualified pump truck lubricants sometimes buy substandard lubricants for cheap. Since the lubricant market is a mixed bag, there are indeed substandard lubricants on the market. Tubing agent, the viscosity of unqualified lubricating agent is not up to standard. When the pump truck moistens the pipe, it relies on the thin layer of mucous membrane for lubrication. If the viscosity of the pipe lubricant is not up to standard, it cannot replace the traditional cement mortar pipe lubricant. There is a saying that goes like this, cheap things are only happy the moment you pay for them, but you are not happy even a minute when you use them! The editor recommends that you look for big manufacturers and don't be greedy for petty gains.
The conditions under construction at each construction site are different, and the pumping equipment used is also different. There are sky pumps and ground pumps. The lubrication methods of sky pumps and ground pumps are slightly different. The quality requirements are also different. The ground pump is larger than the sky pump. When purchasing lubricant from the manufacturer or dealer, be sure to ask clearly whether the lubricant you purchased can lubricate the floor pump? According to the editor's understanding, only the lubricants currently sold on the market and those produced by certain manufacturers can lubricate the floor pumps. The products produced by most manufacturers can only lubricate the sky pumps.
The water used to prepare the lubricant is not enough. The amount of water guided by most manufacturers is 30 kilograms. You can imagine that 30 kilograms of water are poured into the hopper and then pumped out. I believe such a small amount has a big impact. The inner wall of some pipes does not adhere to the pipe lubricant at all, and the pipe lubricating effect cannot be achieved, resulting in pipe blockage. In fact, there are high-concentration lubricants on the market. 300 grams of lubricant can be used to prepare 50 to 60 kilograms of lubricant solution. You can think about whether the 30kg or 50kg lubricant solution can lubricate better, it is clear at a glance! There is a price difference between high-purity lubricants and ordinary lubricants, so you can’t just go for the cheap! In order for the lubricant to achieve the best lubrication effect, the preparation of the high-purity lubricant is slightly different from the ordinary one; when adding the high-purity lubricant to clean water, first turn on the reverse pump and stir for about 10 times. Pause for 3 to 5 minutes to allow the polymer to fully dissolve, then turn on the reverse pump and stir about 10 times before you can start lubrication. The moistening effect of a high-purity moisturizer is definitely better than that of an ordinary moisturizer. </p
微信扫一扫打赏
