Dibutyl tin Diacetate / 1067-33-0 / (C4H9)2Sn(OOCCH3)2

Dibutyltin Diacetate Dibutyltin diacetate is a pale yellow or colorless transparent liquid with an acetic acid odor. Chinese name: Dibutyltin diacetate Foreign name: Dibutyl tin diacetate CA registration number: 1067-33-0 Aliase: Dibutyltin diacetate Introduction CA registration number: 1067-33-0 English name: Dibutyl tin diacetate Alias: dibutyltin diacetate, dibutylstannane diacetate; bis(acetoxy)dibutylstannane; dibutyltin diacetate; dibutyltin acetate; di-n-butyl diacetate; dibutyltin acetate Physical properties Molecular formula: (C4H9)2Sn(OOCCH3)2 Molecular weight: 351.0 Specific gravity (H2O=1): 1.30 Melting point: 10 ° C Physicochemical properties: This product is light yellow or colorless transparent liquid with acetic acid odor, solid or semi-solid below 10 °C, freezing point: 8~10 °C, specific gravity (20 °C): 1.32±0.005g/ml, boiling point: 140-144 ° C / 10 mmHg. Quality index: Appearance: colorless or light yellow transparent liquid Sn content: 32.5±0.5% Relative density (25 ° C): about 1.30 Tin content: 32.0-33.8% Chemical properties Melting point: 7-10 °C (lit.) Boiling point: 142-145 °C 10 mm Hg(lit.) Density: 1.32 g/mL at 25 °C (lit.) Vapor density: 12 (vs air) Vapor pressure: 1.3 mm Hg ( 25 ° C) Refractive index: n20/D 1.471 (lit.) Flash point :>230 °F Water solubility : insoluble CAS Database: 1067-33-0 (CAS DataBase Reference) NIST: Dibutyltin diacetate (1067-33-0) EPA: Stannane, bis(acetyloxy)dibutyl-(1067-33-0) Security Information Dangerous goods mark :T Hazard Category Code : 25-34-36/38 Safety instructions :26-36/37/39-45-37/39-28A Dangerous goods transport number : UN 2922 8/PG 2 WGK Germany :3 RTECS number: WH6880000 TSCA: Yes HazardClass :6.1 PackingGroup : II Customs code :29310095 Toxic Substances Data: 1067-33-0 (Hazardous Substances Data) use Gel catalyst, mainly used as room temperature silicone rubber curing catalyst, especially for deacetic acid type silicone products; characterized by faster catalytic speed than dibutyltin dilaurate, can be used for polyurethane elastomer, sprayed rigid polyurethane foam , hard foam high rebound molding foam, etc. In order to reduce its acetic acid odor, it can be used in combination with dibutyltin dilaurate, usually using dibutyltin diacetate: dibutyltin dilaurate is 1:9 or 2:8. This product should be tightly closed immediately after use. It is easily hydrolyzed when exposed to air, and solids are precipitated at the mouth of the bottle. It is also used as a catalyst for polyurethane coatings. Store It should be kept dry during storage, and the temperature should be above 10 °C. Crystals are precipitated below 10 ° C, and the effect of use is not affected after heating and melting.