1. Product introduction
Concrete pipe moistening agent (Pump Runtong) is the company's patented technology and is produced A polymer material. Pipe moistening agent (pump runtong) can significantly improve the concrete pumping capacity, reduce pipeline friction and pipeline resistance, significantly extend the service life of pump pipes, completely replace pump mortar, reduce processes, shorten operation time, and has the characteristics of rust prevention, fast, and Convenience, environmental protection, money saving and other advantages.
2. Scope of application
Pipe moistening agent (Pump Runtong) products are suitable for pumps Lubricating pump for on-site pump pipes delivering concrete and various dry mortars. It has good adaptability to various grades of concrete and completely replaces the pump mortar of various pump pipes. Pipe moistening agent (Pump Runtong) products can avoid pump clogging accidents of concrete pumps and on-site mortar pumps, reduce transportation vehicles, improve equipment utilization, and reduce the use costs of enterprises using ready-mixed concrete and ready-mixed dry mortar. Using lubricant products saves time, effort and worry, and is a new pumping construction technology.
3. How to use
Before pumping, take the required amount and clean it Pour the dissolved water into the container, then add the lubricating agent (Pump Runtong) evenly and slowly, stir while adding until all is dissolved, then let it sit for 3 minutes, stir again and then use. When using a truck pump to pump concrete, slowly pour the prepared lubricant solution into the hopper along the inner wall of the pump truck hopper and fill it with the pump tube inlet. Then start slowly pouring concrete into the hopper and start adding water at the same time. Carry out concrete and ready-mixed mortar pumping operations. The method is the same when using a ground pump, but attention should be paid to appropriately adjusting the dosage of the product and dissolved water. When using a ground pump, the total length shall not exceed 100 meters. If you need to use a ground pump exceeding 100 meters, purchase a special pump for ground pumps from the company.
JH-RB pump lubrication general dosage preparation table
Transmission pump tube length Product dosage Dissolution Water consumption
Below 65 meters 1 bag More than 30 kilograms
65 meters-100 meters 2 Bags 60kg and above
100-200 meters 3-4 bags 150kg
4. Key points for using the product
1. First, ensure that the pump pipes and connecting parts of the vehicle pump, floor pump, and mortar pump are sealed and have no leakage points;
2. After checking the pump pipe of the pump truck, flush the pump with clean water to ensure that there are no residues, debris and other blockages in the pump pipe;
3. When pumping concrete, the pump runtong solution should be discharged outside the concrete formwork first, and remember not to pour it into the concrete structure;
4. After the concrete pump and ready-mixed mortar pump are pumped, the pump pipes and pump trucks should be flushed with clean water in time;
5. Protective glasses should be worn when using this product . If the product solution is accidentally sprayed into the eyes, rinse immediately with plenty of water.
5. Analysis of economic benefits of using Pump Runtong
Pump Runtong products are used once. It can save about 230 yuan in pump mortar and transportation vehicle costs. Calculated based on the annual output of 200,000 cubic meters of concrete and 100,000 cubic meters of ready-mixed mortar. If the pump is started 2,600 times per year, the annual savings can be about 600,000 yuan.
6. Packaging and storage
Pipe moisturizing agent (Pump Runtong) products are used Biodegradable color laminate packaging, packaging specifications: 300g*100 bags/big bag. This product should be stored in a sun-proof, ventilated and dry place. Shelf life: three years.
</p
微信扫一扫打赏
