Test on the dosage of lubricant

In order to fully moisten and lubricate the pump and pump tube, and to attach a 1mm lubricating layer inside the pump tube, some water must be added according to the length of the pump tube before use. After repeated Adjust and test to find out the most economical and reasonable dosage of pump lubricating agent and water usage, that is, 300g of pump lubricating agent for every 50m of pump pipe can basically meet the usage requirements.

1. Product Description

This product is made of a variety of high molecular polymer materials. At normal temperature, it can be quickly dissolved within 2-4 minutes by mechanical or manual stirring, and form a light yellow stable viscous liquid, thereby achieving the effect of lubricating the pump tube without affecting the performance of the concrete.

◆More convenient It can be quickly dissolved at room temperature

◆More environmentally friendly The product is green and environmentally friendly, and all degradable

◆More efficient Use scientific methods and reasonable formulas to achieve more efficient lubrication

2. Usage

The solution can be prepared according to the type of concrete delivery equipment and the length of the delivery pump pipe, referring to the dosage in the table below. Pour this product into the corresponding volume of water and stir for 2-4 minutes to fully dissolve it. When the solution becomes thick and lubricated, it can be used.

</table

This article is from the Internet, does not represent the position of Epoxy curing agent, reproduced please specify the source.https://www.dmp-30.vip/archives/22005