Epoxy curing agent Knowledge [Bite Chemical] Specific uses and recommended dosage of ultraviolet absorber UV-531

[Bite Chemical] Specific uses and recommended dosage of ultraviolet absorber UV-531

广告位

Image keywords

It is understood that UV absorber UV-531 is in the form of light yellow crystalline powder, insoluble in water, easily soluble in benzene, n-hexane, acetone, and slightly soluble in Ethanol is slightly soluble in dichloroethane, with a melting point of 47-50°C. It can absorb ultraviolet light of 240-340 nm. It has the characteristics of light color, no zero, good compatibility, low migration, and easy workmanship.

The specific uses and recommended dosage of UV absorber UV-531 are as follows:

UV absorber UV-531 is suitable for polyolefin and polyvinyl chloride and other materials, widely used in PE, PVC, PP, PS, PC, plexiglass, propylene fiber and ethyl vinyl acetate. It also provides good light for dry phenolic and acid varnishes, polyurethane coatings, acrylics, epoxy and other air drying products, as well as automotive refinishing paints, powder coatings, polyurethane coatings, rubber products, etc. stabilizing effect.

1. Polyethylene: Both high-density and low-density polyethylene are very effective:

Recommended dosage of polyethylene flat filament, monofilament, and film: 0.2-0.5%;

p>

Recommended dosage in low-voltage devices and blow molded products: 0.15-0.3%;

The effect is very good when used in agricultural films, which can extend the service life by 2-3 times. Recommended dosage: 0.5%.

2. Polypropylene: KINGSORB-531 is very effective in both colored and colorless polypropylene. The amount of UV absorber increases as the thickness of the product decreases.

Dosage of fiber, monofilament, plain yarn, ribbon, mesh and film: 0.5%; injection molding: 0.2-0.3%.

3. Polyvinyl chloride: Ordinary polyvinyl chloride, whether plasticized or non-plasticized, will turn yellow and change its physical properties under ultraviolet irradiation, especially plasticized PVC. Dark spots may also appear on the outside. The general addition amount is: soft PVC: 0.3-2%. Hard PVC: 0.3%.

4. For SBS and PS modified TPR materials, the general dosage is: 0.3%.

5. Others: Recommended dosage: 0.1-0.3%. Before use, a small test should be conducted to determine the final formula.

广告位
This article is from the Internet, does not represent the position of Epoxy curing agent, reproduced please specify the source.https://www.dmp-30.vip/archives/22249

author:

Previous article
Next article
Contact Us

Contact us

+86 - 152 2121 6908

Online consultation: QQ交谈

E-mail: info@newtopchem.com

Working hours: Monday to Friday, 9:00-17:30, closed on holidays
Follow wechat
Scan wechat and follow us

Scan wechat and follow us

Follow Weibo
Back to top
Home
Phone
Products
Search